A four-rail check for an octagonal UM mirror frame

For a regular octagonal mirror frame, choose the UM bit by the profile you want around the glass. JEEFOO lists several profiles in the series. Rout a test length and keep a cross-section beside the drawing. Mark its back so you can compare one ridge with a finished rail. The cutter shapes the length of the moulding. The saw sets the angle at which each rail meets the next.

Octagonal mirror frame: an eight-rail octagonal wooden mirror frame with mitered joints and a UM profile rail section beside it
Octagonal mirror frame: an eight-rail octagonal wooden mirror frame with mitered joints and a UM profile rail section beside it

All eight rails have equal length. If the saw reads zero at a square crosscut, cut the ends at opposite 22.5° settings. Each cut line meets the long edge at 67.5°. From one moulding, cut four scraps equal in length between the long points.

Set all four flat backs on one flat board, long edges out, and seat the three joints. Place a straightedge along the free cut face on rail one. It should also touch the full free face on rail four. Suppose every end is 22.25° off square. The end lines turn through 44.5° per rail. Four turns total 178°, leaving the free faces 2° out of alignment.

A wedge of light at the straightedge warrants another check of the saw on scrap. If both ends lie flush, dry-fit all eight rails and follow one ridge of the UM profile across every joint. A closed ring with a step in the ridge calls for a check against the saved section and the reference face used during routing.

Related reading: GY or GW Router Bit? Best Guide to 2 Groove Floors — choose the bit by the section it cuts, the same section-first check used for an octagonal mirror frame.

Sources for the octagonal mirror frame check

  1. [1] https://www.jeefoowoodbits.com/um-mirror-frame-line-bit-series/
  2. [2] https://media.defense.gov/2014/Jun/20/2002655877/-1/-1/1/140620-N-ZZ182-6521.pdf
  3. [3] https://canadianwoodworking.com/techniques_and_tips/preparing-a-blank-for-segmented-turning/

Similar Posts