PC cutter selection: will the slot retain the screw?

JEEFOO places PC in its keyhole-bit category, while the linked product describes T-profile joinery without numerical dimensions. Before specifying a PC cutter for a hanger, send the proposed slot section and the fastener drawing. The category name does not establish that the available cutter makes that section.

PC cutter: a keyhole slot in a wooden hanger retaining a screw head
PC cutter: a keyhole slot in a wooden hanger retaining a screw head

Infinity describes a keyhole slot with a narrow surface opening and a wider cavity beneath it. The shoulders retain the head. A screw whose stem slides along the opening can still be unsuitable if its head also passes through.

Consider a hypothetical rigid, flat, circular head held parallel to the surface: the opening is 4 mm wide, the cavity 10 mm wide and the screw stem 3 mm across. A 3.5 mm head passes through the opening, so neither shoulder stops it moving straight outward. An 8 mm head meets the width relationship; head thickness and cavity height remain unchecked.

Rockler lists two keyhole cutters with different cutting diameters but the same 1/4-inch tool shank. That shared shank identifies a holding dimension; it does not establish the same finished slot.

Keep the head’s entry opening, retained position and thickness on the hanger drawing. Ask for the actual PC section before matching it to that drawing. These comparisons establish geometric requirements for PC cutter selection, not a hanging-load rating or permission to plunge a particular cutter.

Related reading: GY or GW router bit groove floor and GW cleaning bottom router bit spindle load

Similar Posts